#!/bin/sh # vpu-clock-watchdog.sh — repin RK3328 decoder/RGA CRU dividers to 400 MHz # whenever something moves them. Belt-and-braces for the DTS/initd pins: # the BSP mpp driver never touches rkvdec clocks on RK3328 today, but the # venc driver re-applies its own defaults at every session start, and a # future driver change could do the same to the decoder — this keeps the # proven 400 MHz config live without a reboot. Same logic as the pin=1 # mode of vpu-telemetry.sh, minus telemetry. # # Needs root (cru writes /dev/mem). Run via rc: see vpu-clock-watchdog # initd below, or manually: doas -n /usr/local/bin/vpu-clock-watchdog.sh # # usage: vpu-clock-watchdog.sh [interval-seconds] (default 5) CRU=${CRU:-/usr/local/bin/cru} INTERVAL=${1:-5} # reg lowhalf-target full-write-with-mask # CON(48) 0x1C0: aclk_rkvdec_pre + sclk_vdec_cabac -> 0x0202 each # CON(49) 0x1C4: sclk_vdec_core -> 0x0002 (low field only) # CON(36) 0x190: clk_rga + aclk_rga_pre -> 0x0202 each PIN_48=0xFFFF0202 PIN_49=0x00FF0202 PIN_36=0xFFFF0202 while :; do c48=$($CRU 0x1c0 2>/dev/null) [ $((c48 & 0xffff)) != $((0x0202)) ] && $CRU 0x1c0 $PIN_48 >/dev/null c49=$($CRU 0x1c4 2>/dev/null) [ $((c49 & 0xff)) != $((0x02)) ] && $CRU 0x1c4 $PIN_49 >/dev/null c36=$($CRU 0x190 2>/dev/null) [ $((c36 & 0xffff)) != $((0x0202)) ] && $CRU 0x190 $PIN_36 >/dev/null sleep "$INTERVAL" done